NOTE:
2 Getting Started
2.1 Charging the Battery
Be sure to fully charge the battery before using your device for the
first time.
1. Locate the DC input socket on the left side of the tablet
and open the cover.
2. Insert the DC jack end of the AC adapter into the socket
and the AC plug into the wall socket.
3. The power status LED glows Orange when charging.
If charging for the first time, do not disconnect your
device from AC power until the battery is fully charged,
indi- cated by the power status LED glowing green. This
may take up to 4 hours.
4. Close the cover when charging is completed.
A blinking power status LED indicates an abnormal charging
condition. Check that the AC adapter is properly inserted into
the DC input socket and that the device is not charging in high
NOTE:
temperature conditions, resulting in an overheated battery.
Summary of Contents for IMT-BT
