ADLINK Technology cPCI-6510 Series, User Manual, Page: 99 / 112

84 IPMI User Guide
Broadcast “Get
Device ID”
20.9 App 01h
This is a broadcast version of the ‘Get
Device ID’ command that is provided for
the ‘discovery’ of Intelligent Devices on
the IPMB
IPMI Messaging Support Commands
Send Message 22.7 App 34h
The
Send Message
command is used for
bridging IPMI messages between
channels, and between the system
management software (SMS) and a given
channel.
BMC Watchdog Timer
Reset Watchdog
Timer
27.5 App 22h
The
Reset Watchdog Timer
command is
used for starting and restarting the
Watchdog Timer from the initial
countdown value that was specified in the
Set Watchdog Timer
command.
Set Watchdog
Timer
27.6 App 24h
The
Set Watchdog Timer
command is
used for initializing and configuring the
watchdog timer. The command is also
used for stopping the timer.
Get Watchdog
Timer
27.7 App 25h
This command retrieves the current
settings and present countdown of the
watchdog timer.
Event Commands
Set Event Receiver 29.1 S/E 00h This global command tells a controller
where to send Event Messages.
Get Event Receiver 29.2 S/E 01h
This global command is used to retrieve
the present setting for the Event Receiver
Slave Address and LUN. This command
is only applicable to management
controllers that act as IPMB Event
Generators.
Platform Event
Message
29.3 S/E 02h
This command may be thought of as a
request for the BMC to process the event
data that the command contains.
Typically, the data will be logged to the
System Event Log (SEL).
Command
IPMI
Spec
NetFn CMD Description