Page 7
2.3A Wiring the plug for a 230 Volts AC machine
As the colours
of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:-
1.
The wire
, which is, coloured green and yellow must be
connected to the terminal in the plug, which is marked by the
letter E, or by the safety earth symbol coloured green, or green
and yellow.
2.
The wire
coloured blue must be connected to the terminal,
which is marked with the letter N, (Neutral connector)
3.
The wire
coloured brown must be connected to the terminal,
which is marked with the letter L, (Live connector)
NOTE:
Replacement of the mains cable must be done by a competent
service engineer.
2.4
Adjusting the pressure
This press is fitted
with a pressure-adjusting unit, which enables the
heat plate assembly to be raised or lowered by use of a pressure
adjustment knob located on the top of the machine:
a)
To increase pressure
or to use thinner materials turn knob
clockwise.
b)
To decrease pressure
or to raise the heat plate assembly to
enable thicker materials to be used, turn the adjustment knob
anticlockwise.
NOTE
DO NOT adjust the pressure when the machine is clamped shut
CAUTION
Never increase the pressure to the extent of requiring undue force
to lower the toggle/heat plate assembly into the lock position, as this
will place excessive stress on the press frame, resulting in
permanent damage to the press.
Please refer to page 15 showing the operation of the control unit.
