ADJ Products, LLC - www.adj.com - WiFly Par QA5 WH User Manual Page 27
ADJ Products, LLC - www.adj.com - WiFly Par QA5 WH User Manual Page 26
WiFly Par QA5 WH Battery Replacement
1. Uscrew the four thumbscrews
that hold the battery door in
place.
2. Remove the battery door to
access the battery.
4. Carefully pull out the battery
connector cables.
3. Carefully remove the battery
from the compartment.
5. Carefully disconnect the bat-
tery cables.
6. Once the cables have been disconnected you can now con-
nect your new battery. Put everything back together in reverse
order.
WiFly Par QA5 WH Initialize the Unit
After replacing either the PCB or the battery, you must perform the
following steps to initialize the unit. If the unit is not initialized after
replacing either of these parts, the unit battery life will be inaccurate in
future use.
1. Make sure the unit is unplugged from any power source. Switch
OFF the BATTERY switch and switch ON the LOAD switch. Simulta-
neously, press the MODE, SET UP, UP, & DOWN buttons.
2. While pressing these buttons, plug the unit into an AC power
source. The unit should display “-002”. Simultaneously release all four
buttons. The unit should display that last running mode. This indi-
cates that the unit has entered initialization mode successfully.
Note: When the four buttons have not been pressed simultane-
ously, and then you release the buttons, 1 of 2 situations will
occur which will let you know that you have not entered the ini-
tialization mode successfully.
1. When plugging the unit into a power source, the display reads
“1234”. You have not entered the initialization mode.
2. When plugging the unit into a power source, the display reads
“-002”, but when you release the buttons simultaneously, the
display reads “StAr”, instead of the last running mode. You have
not entered the initialization mode.
3. After you have started the initialization mode, switch LOAD switch
to OFF and switch ON the battery switch. Doing this will fast charge
the battery to full status. Once you have reached full charge the dis-
play will show “b100”.
4. Unplug the power cord and switch ON the LOAD switch. Set the
unit to Static Color mode. Use the UP or DOWN buttons so that the
display shows “CL 15” (RGBA color full on) to fast discharge the
battery. Discharge the battery so that the display shows “b000”. This
means the battery charge is gone. The unit has now been initialized
successfully. Go ahead and recharge your battery.
