A.D.J. Supply Europe B.V. – www.americandj.eu – SP-1500 DMX MKII Strobe Manual Page 3
INTRODUCTION
Aggressor Tri LED™ Introduction
Thank you for purchasing the American DJ SP-1500 DMX MKII Strobe. To optimize the performance of this
product, please read these operating instructions carefully to familiarize yourself with the basic operations
of this unit.
Customer Support:
American DJ
®
provides a toll free customer support line, to provide set up help and to answer any question
should you encounter problems during your set up or initial operation. You may also visit us on the web at
www.americandj.eu for any comments or suggestions.
E-mail: [email protected]
To purchase parts online visit www.adjparts.eu
Warning!
To prevent or reduce the risk of electrical shock or fire, do not expose this unit to rain or
moisture.
Caution!
There are no user serviceable parts inside this unit. Do not attempt any repairs yourself, doing so
will void your manufactures warranty. In the unlikely event your unit may require service please contact
your American DJ reseller.
• Do not obstruct the air vents.
• Do not touch the unit while it’s hot.
Do not discard the shipping carton in the trash. Please recycle whenever possible.
Aggressor Tri LED™ Features
FEATURES
• Includes hanging bracket
• Sound-Active
• DMX-512, Master/Slave
• Electronic Dimmer 0-100%
• Built-in microphone
• Compatible with UC3-Series controllers
INSTALLATION
1.
POWER INPUT:
AC 230V 50Hz
2.
FUSE:
20A/15A
3.
DMX IN:
XLR 3 Pole male socket.
4.
DMX OUT:
XLR 3 Pole female socket.
5.
UC3 Remote input:
connect the UC3
to the ¼” microphone Jack to control
the unit for Speed, Blackout and Brightness.
6.
DMX DIP SWITCH:
Dip switch 1-9 are used to set the DMX address of the unit.
7.
DIMMER:
This knob is used to adjust the brightness of the units.
8.
SPEED:
This knob is used to adjust the strobing speed.
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Use a safety chain to secure the strobe. The equipment must
be fixed by professionals. And it must be fixed at a place where is out of reach of people.
