ADJ REVO 4 IR, User Instructions, Page: 8 / 10

ADJ Products, LLC - www.adj.com - Revo 4 IR Instruction Manual Page 15
ADJ Products, LLC - www.adj.com - Revo 4 IR Instruction Manual Page 14
The UC IR infrared remote (sold separately) gives you control of
various functions (See below) . To control the fixture you must aim
the remote at the front of the fixture and be no more then 30 feet
away.
STAND BY - Pressing this button will blackout the fixture. Press the
button again to return to the initial state.
FULL ON - Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
FADE/GOBO - This button is invalid for this fixture.
“” and “DIMMER -” - These buttons are invalid for this
fixture.
STROBE - Press and hold this button for strobing.
COLOR - Press this button to activate color mode. Use buttons 1-5
to select your desired color.
1-9 - Use buttons 1-9 to select your desired color when color mode
is active or your desired show when show mode is active.
SOUND ON & OFF - Use the buttons to activate and deactivate
sound active mode.
SHOW 0 - Press this button to select Show 0. Use buttons 1-9 to se-
lect Shows 1-9. Press the Show 0 button twice to run Show 10, and
press button #1 twice to run show 11.
Revo 4 IR UC IR Control Revo 4 IR Master-Slave Configuration
Revo 4 IR Power Cord Daisy Chain
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 12 fixtures maximum for 120V and 21 fixtures maxi-
mum for 230V. After the maximum amout of fixtures is connected
you will need to use a new power outlet. They must be the same
fixtures. DO NOT mix fixtures.
Master-Slave Configuration
This function will allow you to link up
to 16 units together and operate without a controller. In a Master-Slave
set up, one unit will act as the controlling unit and the others will react
to the controlling units programs. Any unit can act as a Master or as a
Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit press the MENU button until “ SLND ” is dis-
played, and press ENTER. Use the UP and DOWN buttons to
scroll to the “ MAST ” setting and press ENTER.
3. After setting the Master unit to the master setting find and set
your desired operating mode.
4. On the slave units press the MENU button until “ SLND ” is dis-
played, and press ENTER. Choose either “ SL 1 ” or “ SL 2 ” and
press ENTER. See page 9 for more info.
5. The slave units will now follow the Master unit.