ADJ REVO 4 IR, User Instructions, Page: 6 / 10

ADJ Products, LLC - www.adj.com - Revo 4 IR Instruction Manual Page 11
• MASL (Master Slave) - If the DMX signal is lost or power is applied,
the unit will automatically go into Master Slave mode and run a built-in
show.
•
BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
•
LAST - If the DMX signal is lost the fixture will stay in the last DMX
setting. If power is applied and this mode is set, the unit will automati-
cally go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
LED -
With this function the LED display will turn off
after 2 minutes.
1. Press the MENU button until “LED” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to allow the LED display to turn off after 2 minutes.
Press any button to turn on the LED display again.
3. Press ENTER to confirm and exit.
DISP -
This function will reverse the display 180º.
1. Press the MENU button until “DISP” is displayed, press ENTER.
2. Press the UP button to select “DISP” to activate this function, or
“DSIP” to deactivate this function.
3. Press ENTER to confirm.
Revo 4 IR System Menu
ADJ Products, LLC - www.adj.com - Revo 4 IR Instruction Manual Page 10
1-12. Programs 1-12 are preset shows, while “Sh 0” is random mode.
Press the UP or DOWN buttons to find your desired show and press
ENTER to confirm.
3. Press ENTER to confirm, and then press and hold the MENU button
for at least 3 seconds.
SOUN
- In this mode you can run the unit in sound
active mode
1. Press the MENU button until “SOUN” is displayed, press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or DOWN
buttons to select one or the other.
3. When you have made your selection, press the ENTER, and then
press and hold the MENU button for at least 3 seconds to confirm.
SENS -
In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until “ SENS ” is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN
buttons to adjust the sound sensitivity. 0 being the least sensitive,
and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
DNST
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “ DNST ” is displayed, and either
“ MASL ”, “ BLND ”, or “ LAST ” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP
or DOWN buttons to choose an operating mode you would like the unit
to start up in when power is applied or the DMX signal is lost.
Revo 4 IR System Menu