A.D.J. Supply Europe B.V. – www.americandj.eu – Mega Tri BAR
Instruction Manual Page 13
OPTIONAL IR WIRELESS CONTROLLER
The optional IR Remote (sold separately) gives the freedom to control your fixture from a
distance and not have to use the onboard controls.
To control the your desired fixture you must aim the controller at the front of the fixture and be no
more the 30 feet away. Note: The IR Remote can be used when the fixtures are connected to a
DMX controller.
Blackout-
Pressing this button will blackout the fixture.
Autorun
-
This button will run an automatic program. You can adjust the amount of program cycles
by pressing the AUTO RUN button again. The display will show “n.XXX”, “XXX” representing the
current number shown. Press the “+” and “-” buttons to increase or decrease the amount of
program cycles.
PROGR
A
M SELECTION -
This button will let you access one of the seven static color selections.
Pressing this button and then press the “+” or “-” to navigate through the different programs.
FADE -
This button will activate the fade effect. You can control the fade speed by pressing the
“+” and “-” buttons. Press this button again to exit fade mode.
SPEED -
Press this button and use the “+” & “-” buttons to adjust the speed of a program.
SOUND
A
CTIVE -
This button activates sound active mode. Sound active mode will not work for
outdoor LED lights.
SL
A
VE -
This designates the fixture as a slave fixture in a master/slave configuration.
RGB -
Press either one of these buttons, and then press the “+” and “-” to adjust the brighness.
“+” and “-” Buttons -
Use these buttons to adjust the fade speed, Auto Run speed, dimming,
and program selection.
DMX CONTROL MODE:
For DMX control mode, at least one dip switch must be set on ON.
1, DMX-512 connection / connection between fixtures
2,
Note:
The wires must not come into contact with each other, otherwise the machines will not
work at all, or will not work properly.
3, Only use a stereo shielded cable and 3-pin XLR-plugs and connectors to connect the DMX
controller with the machine or one machine with anothers.
4, Connect the DMX-output of the controller with the DMX-input of the first machine in the DMX-
chain, then connect the DMX-output of the first machine with the DMX-input of the next machine
of the DMX-chain.
5, Addressing the machines, all of dipswitches set the DMX addresses.
6,
Note:
The machines have one channel DMX. it control the output fog or not. when the DMX
value less than 127, the output of fog is turned off, when the DMX value more or equal 127, the
output is turned on.
