Mega QA Go
Battery Precautions
ADJ Products, LLC — www.adj.com — Mega QA Go - User Manual — Page
5
•
To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture
•
Do not spill water or other liquids into or on to your unit.
•
Do not attempt to operate this unit if the power cord has been frayed or broken. Do not attempt to
remove or break off the ground prong from the electrical cord. This prong is used to reduce the risk
of electrical shock and fire in case of an internal short.
•
Disconnect from main power before making any type of connection.
•
Do not remove the cover under any conditions. There are no user serviceable parts inside.
•
Never operate this unit when it’s cover is removed.
•
Never plug this unit in to a dimmer pack
•
Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6” (15cm)
between this device and a wall.
•
Do not attempt to operate this unit, if it becomes damaged.
•
This unit is intended for indoor use only, use of this product out doors voids all warranties.
•
During long periods of non-use, disconnect the unit’s main power.
•
Always mount this unit in safe and stable matter.
•
Power-supply cords should be routed so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to the point they exit from the unit.
•
Cleaning -The fixture should be cleaned only as recommended by the manufacturer. See page 31
for cleaning details.
•
Heat -The appliance should be situated away from heat sources such as radiators, heat registers,
stoves, or other appliances (including amplifiers) that produce heat.
•
The fixture should be serviced by qualified service personnel when: A. The power-supply cord or the
plug has been damaged. B. Objects have fallen, or liquid has been spilled into the appliance. C. The
appliance has been exposed to rain or water. D. The appliance does not appear to operate normally
or exhibits a marked change in performance.
Mega QA Go
Safety Precautions
Do Not Short Circuit the Battery:
Do not short circuit the battery. It generates a very high current which could cause the battery to
overheat, resulting in electrolyte gel leakage, harmful fumes, or explosion. The LIR tabs may easily
short-circuit by placing them on conductive surface. A short circuit may lead to heat build up and
damage of the battery. An appropriate circuitry with PCM is employed to protect accidental short circuit
of the battery pack.
Mechanical shock:
Dropping the unit, impact hit, bending, etc., may cause failure or shortened life of the LIR battery.
Battery connection:
•
Direct soldering of wire leads or devices to the battery is strictly prohibited.
•
Lead tabs with pre-soldered wiring shall be spot welded to the batteries. Direct soldering may cause
damage of components, such as separator and insulator, by heat build up.
Prevention of short circuit within a battery pack:
There is enough insulation layers between wiring and the batteries to provide extra safety protection.
The battery pack is constructed in a way that no short circuit will occur which may cause smoke or fire.
