ADJ Jolt Bar FX, User Manual

Page: 11 / 32

11
I N S TA L L AT I O N
CONNECTOR PLATE:
Each unit includes a connector plate that can be used to secure two adjacent mounted units together.
To install the connector plate, follow the directions below:
1. Locate the connector plate. It is affixed to back of the unit, near one of the ends of the bar. See
the illustrations below for guidance.
2. Remove the two (2) screws holding the connector plate in place, as well as two (2) screws on the
end of each adjacent unit, for a total of six (6) screws. Remove the connector plate.
3. Place the connector plate across the gap between the two units, making sure to align the plate
with the four (4) screw holes. Reinstall the four (4) screws that secure the connector plate in place,
as well as the two (2) additional screws that held the connector plate in its storage position. The
installation is now complete.