ADJ Products, LLC - www.adj.com - H2O DMX IR Instruction Manual Page 15
H2O DMX IR
27 Degree Lens Install
The installation of the lens is a
pretty easy process. Please be
very carefull when doing this
install.
Unscrew and remove the focus
lens. Using your thumb, gently
push the lens outward until it
“pops” out.
When the lens “pops” out, the pic-
ture to the left is what you should
see. Remove the lens and retainer
ring.
Flip the focus lens barrel over and
insert the lens. Carefully insert the
retainer ring. Please do this very
carefully. Make sure retainer ring is
in correctly, flesh against the lens.
Now you can screw the focus lens
back into the H2O DMX IR.
ADJ Products, LLC - www.adj.com - H2O DMX IR Instruction Manual Page 16
H2O DMX IR
Fuse Replacement
Fuse Replacement:
Unplug the unit from any power source it may
be connected to. Once the power has be disconnected, use a phillips
head screw driver to unscrew the fuse holder located around the I.E.C.
inputs. Remove the bad fuse and replace with a new one, and screw
the fuse holder back in.
Warning: If after replacing the fuse you continue to blow fuses, STOP
using the unit. Contact customer support for further instructions. Con-
tinuing to use the unit may cause serious damage.
Trouble Shooting:
Listed below is a problem that you may encounter,
with a solution.
No light output from the unit;
1. Be sure the fuse has not blown. The fuse is located on the rear
panel inside the power socket. See Fuse Replacement.
H2O DMX IR
Trouble Shooting
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the
internal and external lenses should be carried out periodically to opti-
mize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Clean the external optics with glass cleaner and a soft cloth every
20 days.
3. Always be sure to dry all parts completely before plugging the
unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom-
mend cleaning on a monthly basis. Periodic cleaning will ensure lon-
gevity, and crisp beam output.
H2O DMX IR
Cleaning
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 10 fixtures maximum for 120V and 17 fixtures maxi-
mum for 230V. After the maximum amout of fixtures is connected
you will need to use a new power outlet. They must be the same
fixtures. DO NOT mix fixtures.
H2O DMX IR Power Cord Daisy Chain
