ADJ FLA120, User Manual

Page: 14 / 23

14
S Y S T E M M E N U
Static Color Mode:
1. Plug the fixture in and press the MODE button until “CLXX” is displayed.
2. There are 32 colors to choose from. Select your desired color by pressing the UP and DOWN
buttons. After you have selected your desired color you can activate strobing by pressing the SETUP
button to enter the strobe mode.
3. “S.XXX” will be displayed, indicating that the device is in strobing mode. The strobing can be adjusted
between “S.000” (strobe off) and “S.015” (fastest strobe).
Default Running Mode:
This is a default running mode. When this mode is activated, all modes will return to their default
settings.
1. Plug the fixture in and press the MODE button until “dXX” is displayed. “XX” represents either “on”
or “oFF”.
2. Press the SETUP button until “dEFA” is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.
ADJ LED RC3:
This function is used to activate or deactivate the ADJ LED RC3 (Remote Control). When this function
is activated, the fixture can be controlled using the ADJ LED RC3. Please see the ADJ LED RC3
Operation section of this manual for ADJ LED RC3 controls and functions.
1. Press the MODE button until “dXX” is displayed. “XX” represents either “on” or “oFF”.
2. Press the SETUP button until “IrXX” is displayed. “XX” represents either “on” or “oF”.
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
DMX State:
This setting defines the behavior of the fixture in the event that the DMX signal is lost or interrupted. It
also determines the mode that the fixture will default to when it is powered on.
1. Press the MODE button until the DMX address is displayed.
2. Press the SETUP button until “No-X” is displayed. “X” represents a number between 0-2.
3. Use the UP or DOWN buttons to select the operating mode you would like the unit to start up in
when power is applied or the DMX signal is lost.
• “N0-0” (BLACKOUT) - If the DMX signal is lost or power is applied, the unit will automatically go into
stand by mode.
• “N0-1” (HOLD) - If the DMX signal is lost, the fixture will stay in the last DMX set up. If power is
applied and this mode is set, the unit will automatically go into the last DMX set up.
• “N0-2” (FADE PROGRAM) - If the DMX signal is lost or power is applied, the unit will automatically
run the fade program.
Dimmer Curve:
This is used to set the dimmer curve used with DMX mode. See the Dimmer Curve Chart section of this
manual for more information.
1. Plug the fixture in and press the MODE button until the DMX address is displayed.
2. Press the ENTER button until “dr-X” is displayed. “X” represents the current dimming mode.
3. Use the UP and DOWN buttons to find your desired dimmer curve. Press SETUP when you are finished.
• dr-0 - Standard
• dr-1 - Stage
• dr-2 - TV
• dr-3 - Architectural
• dr-4 - Theater