ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 13
Encore Burst 100 IP
Operating Instructions
DMX Address
-
DMX Address Setting
.
1. Press either the MENU, UP, or DOWN buttons until “DMX Address” is displayed and press ENTER.
2. The current DMX address will now be displayed. Press the UP or DOWN buttons to find your
desired DMX address and press ENTER to confirm your setting. Press the MENU button to exit
without any changes.
DMX CH Mode
- This will let you select your desired DMX channel mode.
1. Press either the MENU, UP, or DOWN buttons until “DMX CH Mode” is displayed and press
ENTER.
2. The current DMX channel mode will now be displayed. Press the UP or DOWN buttons to find
your desired DMX channel mode and press ENTER to confirm your setting. Press the MENU
button to exit without any changes.
No DMX State
- This mode is used as a precaution mode. In case the DMX signal is lost
or interrupted, the operating mode chosen in this setup is the running mode the fixture will revert
to when the DMX signal is lost.
1. Press either the MENU, UP, or DOWN buttons until “No DMX State” is displayed and press ENTER.
2. Press the UP or DOWN buttons to find the operating mode you would like the unit to automatically
revert to if the DMX signal is lost or interrupted.
-
Hold Last
- If the DMX signal is lost or interrupted, the unit will stay in the last DMX setting.
-
Blackout
- If the DMX signal is lost or interrupted, the unit will automatically go into standby mode.
-
Manual
- If the DMX signal is lost or interrupted, the unit will default to the settings made under the
“Manual Control” function. See “Manual Control” on page 15 for more information.
3. Once you have found your desired setting press ENTER to confirm.
Dim Modes
- This will let select your desired dimmer curve. In this mode the dimmer
speed can also be adjusted. The dimmer speed adjustment will affect all dimmer curve modes.
1. Press either the MENU, UP, or DOWN buttons until “Dim Modes” is displayed and press ENTER.
2. 1 of 6 dimmer curves or dim speed will be displayed. “
Standard
”, “
Stage
”, “
TV
”, “
Architectural
”,
“
Theatre
”, or “Stage 2”. See the dimmer curve chart on page 18 for more info.
3. Press the UP or DOWN buttons to find your desired dimmer curve and press ENTER to confirm
.
LED Refresh Rate
- With this function you can adjust the dimming frequency.
1. Press either the MENU, UP, or DOWN buttons until “LED Refresh Rate” is displayed and
press ENTER.
2. Use the UP or DOWN buttons to adjust the dimming frequency between 900hz, 1000hz, 1100hz,
1200hz, 1300hz, 1400hz, 1500hz, 6000hz, or 25000hz.
3. Once you have found your desired setting press ENTER to confirm.
