ADJ DOT903, User Manual, Page: 9 / 22

9
SYSTEM MENU
Control Panel Lock: The control panel will lock itself after 30 seconds if nothing is pressed. To
unlock the control panel, press the MODE button for 3 seconds.
DMX Mode - Set the DMX Address and DMX Channel Mode.
1. Press the MODE button until “AXXX” is displayed. “XXX” represents the currently set address.
2. Use the UP or DOWN buttons to change the DMX address.
3. After setting your DMX address press ENTER. You can now select your desired DMX channel
mode. Use the UP or DOWN buttons to find your desired DMX channel mode, then press ENTER
when you find your desired DMX channel mode.
4. After you press ENTER you can now set your dimmer curve. There are 5 dimmer curve settings.
See Dimmer Curve below for the different curves. Select your desired dimmer curve setting, and
press ENTER.
5. After you press ENTER, you can set your NO DMX setting. This setting defines how the fixture
will behave in the event that the DMX signal is lost or interrupted. Press ENTER when you are fin-
ished to return to the DMX address setting.
Dimmer Curve - This setting will let you select your desired dimmer curve.
1. Press the MODE button until “AXXX” is displayed. “XXX” represents the currently selected
address.
2. Press the SET UP button until “dcXX” is displayed, then press ENTER.
3. 1 of 5 dimming curve settings will be displayed: Standard, Stage, TV, Architectural, or Theatre.
Use the UP and DOWN buttons to select your desired dimming curve and press ENTER to con-
firm.
NO DMX - This mode can be used as a precaution mode, and defines how the device will
behave in the event that the DMX signal is lost, interrupted, or power is lost. You can also set
this as the operating mode you would like the unit to return to when power is applied.
1. Press the MODE button until “AXXX” is displayed. “XXX” represents the currently selected
address.
2. Press ENTER until one of the following is displayed; “Soun”, “blc”, or “Hold”. Use the UP or
DOWN buttons to choose an operating mode you would like the unit to start up in when power is
applied or the DMX signal is lost.
• Soun (Sound) - If the DMX signal is lost, interrupted, the unit will automatically go into sound
active mode.
• blc (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into stand
by mode.
• Hold - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is applied
and this mode is set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Secondary Mode - This will let you set your unit as a secondary unit in a primary/secondary
configuration.
1. Press the MODE button until “SEcd” is displayed.
2. Your unit will now follow the Primary.