ADJ 123000300, User Instructions

Page: 28 / 33

ADJ Products, LLC - www.adj.com - Focus Spot 5Z User Manual Page 27
Focus Spot 5Z Gobo Replacement
The gobo’s featured in this unit are interchangable. Remember when changing these gobo’s that
they are thin and easy to bend.
If your removing/replacing the glass gobo, please be very careful. REMEMBER, this is a glass gobo,
it is delicate. Please be very careful when removing/replacing any of the gobo’s.
Caution! Never open the unit when in use. Always disconnect the main power before attempting to
change the gobos.
Locating the Gobo wheel: After disconnecting the main power, position the head with the lens
facing forward. When looking through the front lens, position the head so that the frost filters are
located at the top (see image below). When the frost filters are located at the top, the shell that
needs to be uscrewed and removed is now facing up.
1. To change a gobo, uscrew the 4 screws that secure the shell to the unit. Gently lift and remove the
shell.
2. Once the shell is removed, you will be able to access the gobo wheel. Turn the wheel until you
come across the gobo you would like to change.
3. Once you have found the gobo you would like to change, use your finger to carefully turn the
small inner gear so that the “alignment dot” on the inner gear, lines up with the gobo you would
like to replace (Figure 1).
4. Once the gobo and “alignment dot” are lined up, CAREFULLY, from underneath the gobo wheel,
push the gobo housing with gobo up and pull the housing out.
CAUTION! Do not put to much pressure on the gobo itself due to the fact it is thin and it can bend.
5. Using your fingernail or needle nose pliers, CAREFULLY remove the retainer ring that secures the
gobo in place. After the retainer ring is removed, your are able to remove the gobo (Figure 2).
6. Change the gobo and replace the retainer ring.
NOTE: The black side of the gobo faces outwards in the gobo holder.
7. To reinsert the gobo housing back into the gobo wheel, make sure the “alignment dot” lines up
with the “protruding pin” (Figure 3). The “protruding pin” secures the gobo housing to the gobo
wheel. You will feel the gobo housing “lock” into place when the housing is inserted correctly.
8. Reassemble the unit.
FROST FILTER FROST FILTER