Sidewinder X1 Belt Kit assembly manual
P a g e
21 | 30
Figure 27 Rear roller mount
FRONT ROLLER MOUNT:
Take the ROLLER with BLOCK BEARINGS on it, install it with
M6x30 SCREWS and M6 NYLOCK NUTS, please be aware in this step belt have to be
inserted as shown in the next picture, DO NOT ADJUST SCREWS YET, JUST INSTALL
SCREWS ON BOTH SIDES:
ROLLER HAS TO BE CENTERED!
Belt tensioning:
Using a measure tape, compare both ends of ROLLER SHAFTS (RODS),
on both sides, adjust Screws until measure is the same on both sides, approximately
dimension is about 610 to 620 mm (size must be taken on the external side of each
rod), do not exceed tension on belt, otherwise it will cause a lot of friction problems
and misalignment:
Note:
One way to check for the right belt tension and alignment is once done previous
step, roll the belt by hand and it have to move easy, smooth and straight without