ADIC AIT 100D, Installation And Operating Manual, Page: 48 / 50

38
Index
— A —
AC Power Connector, 4
Active Head Cleaner, 2
active termination, 14
ADIC Technical Assistance Center, 7 , 24 , 29 , 33
Advanced Intelligence Tape, 38
AIT, iii , 2 , 3 , 6 , 36 , 38 , 39
AIT data cassette, 5
ALDC, iii , 2
AME, 2 , 38
application software, 2 , 22
Application Software, 7
ASPI, 3
— B —
backup software, 14
Bad environment, 31
Busy LED, 4 , 16 , 30 , 36
— C —
cassette status, 28
Causes of the Media Warning Message, 31
Check the Terminating Resistor, 13
cleaning cassette, 24 , 25 , 38
Cleaning Request message, 2 , 24 , 36
Cleaning Tape, 18
Cleaning the Enclosure, 25
Cleaning the Tape Heads, 24
compressed mode, 5
Connecting More than One 70D/100D, 12
Copyright Notice, iii
Copyright Notice (Europe), iv
— D —
Declaration of Conformity, vi
Defective drive, 31
Dirty ("Stained") heads, 31
DLC, iii , 2 , 38
drive fault conditions, 28
drive firmware, 24
drive head cleaning, 31
Drive LED Status, 28
drive LEDs, 28 , 31
Drive Operating Condition, 19
Drive State, 17 , 18
drive status, 2 , 4
dust contamination, 31
— E —
eject button, 4 , 21 , 22
electrical interference, 31
EMI/RFI Compliance, v
Erasing, 18
error codes, 28
error messages, 2 , 4 , 28 , 32
Error Rate Warning, 24
extreme environmental conditions, 2
— F —
ferrite bead, 38
file access time, 2
Flash memory IC, 5
front panel LCD display, 38
— H —
heat, vii , 31
helical scan device, 5
hierarchical storage management, 38
High Humidity, 31
host adapter, 10 , 11 , 13
host computer, 4 , 7 , 10 , 11 , 16 , 38 , 39
host system, 7 , 16 , 20
hosting environment, 3
HSM, 38
— I —
Installing the Backup Software, 14
Installing the Host Adapter, 10
interface cable, 4 , 11
— J —
jack screws, 11
— L —
label, 20 , 25
LCD, 2 , 4 , 16 , 17 , 18 , 20
LCD Error Message, 28