17
STOP OF THE MACHINE AFTER CLEANING OPERATION
BREAK WASHING MODE
IN AUTOMATIC OR MANUAL WORKING MODE:
1.
At the end of the washing
cycle, keeping the button
(1) pressed, the functioning
of BREAK WASHING is
chosen. When the signal
lamp (2) is on, then the
machine is in BREAK
WASHING mode.
2.
When the mode is on, the
display will show BREAK
WASHING.
In this way automatically the brushes lift, the solenoid valve shuts
down and it is possible to finish the drying operation for a total time
of about 15 seconds, afterwards also the squeegee is lifted and the
suction stops.
NOTE: all these phases are carried out with the machine operating,
so that the squeegee can dry the interested cleaning area from the
“drying phase of the brushes” and furthermore can dry the suction
hose of its dirty water. At any time it is possible to interrupt the
procedure BREAK WASHING by stopping the drive.
During the BREAK WASHING, if the drive pedal is released for more
than 3 seconds the machine will automatically switch to manual
mode (MAN).
The mode (BREAK WASHING) is specific for the transfer at the end
of the cleaning operation.
DAILY MAINTENANCE
DRAINING AND CLEANING THE RECOVERY TANK
1.
Hold the exhaust hose placed on the rear part of the machine
after having taken it off from its fixing support.
2.
Take off the plug from the exhaust hose acting upon its lever
and empty the recovery tank into appropriate containers, in
compliance with the respective rules what the liquid disposal
concerns.
3.
After the tank is completely drained, take off the drain box (1)
by releasing the lever (2) and unscrew the cap (3).
4.
Clean the inside of the tank using a water jet.
CLEANING THE SUCTION FILTER
1.
Open the cover (1) and unscrew the knob (2) to release the filter
protection (3).
2.
Rotate the filter protection clockwise to release it.
3.
Take off the filter and
its protection.
4.
Clean with a water jet
especially the bottom
part and the sides of
the filter.
5.
Do the cleaning
procedure precisely.
6.
Reassemble the filter.
Absolutely do not clean the inside of the recovery tank cover
otherwise the suction motor will be damaged irreversibly.
