RECOVERY TANK
Check that the suction filter cap (1) is properly secured after turning
the levers and that is properly connected to the suction motor hose (2).
Verify that the squeegee hose is properly inserted in its locations (3)
and (4), also check that the draining hose cap (5) on the front of the
machine is closed.
12
FLOOR CLEANING
CONNECTING THE BATTERY CONNECTOR AND SWITCHING ON THE
MACHINE
Once that the battery charging has been completed:
1. Disconnect the connector (2) of the battery charger from the
battery connector (1).
2. Connect then the battery connector (1) to the machine connector
(3).
DETERGENT SOLUTION TANK
Grab the hose cap (1) located
on the left side of the machine,
pull out the hose and after
opening the cap, connect the
hose to the water valve. Fill the
solution tank with clean water
at a temperature not over 50°C.
Add detergent solution with
the concentration provided by
the manufacturer. To avoid the
excessive production of foam
that could cause damages
to the suction motor, use a
minimum percentage detergent
solution.
On the rear part of the machine
it is located the water level
hose, which allows to see the
amount of detergent solution
inside the tanks, both when
loading it and when working.
Screw the detergent solution
cap.
Always use a foam-controlled detergent. To safely avoid the production
of foam, before starting to work, add also a small amount of anti-foam
solution in the recovery tank.
Never use pure acids.
3S “SOLUTION SAVING SYSTEM” (OPTIONAL)
Is a system that allows the controlled use of the detergent solution
during the work.
To activate it press button (1),
then the water symbol on the
display will start to blink.
Select the 3S system using the
buttons (2).
When the 3S system stops
to blink, the system is being
selected.
3SD “SOLUTION SAVING SYSTEM DISPENSER” (OPTIONAL)
Is a system that allows a pre-defined dosing of the percentage of
detergent solution that is going to mix with the water coming from the
solution tank.
To activate it press button (1) ,
the water symbol will blink on
the display.
Select the 3SD system using the
buttons (2).
When the 3SD system stops
to blink, the system is being
selected.
The detergent is stored in a 7
liters capacity tank, placed in
the rear part of the machine.
To fill the detergent, unscrew
the cap shown in the drawing.
