8
BEFORE USE
HANDLING OF THE PACKED MACHINE
The machine is supplied with suitable packing foreseen for fork lift
truck handling.
For the package dimensions please look at the “TECHNICAL
DESCRIPTION” table.
Do not place any packings on top.
UNPACKING THE MACHINE
1.
Remove the external packing.
2.
Move the machine backwards, as indicated in the figure, avoiding
heavy contacts to mechanical parts.
3.
Keep the pallet for eventual transport.
The portable slope is not included in the packaging.
ACCESS TO THE BATTERY COMPARTMENT
1.
Bring the machine on a levelled surface.
2.
Rotate the seat platform forward up to the blocking of the
support.
3.
Having finished any intervention, to close the battery
compartment, after having released the support, reposition the
seat platform.
BATTERY INSTALLATION AND SETTING OF THE BATTERY TYPE
The machine is equipped either with batteries in serial connection or
elements of DIN-type assembled together and connected in series for a
total of 36 Volt, placed in its appropriate compartment under the seat
platform and must be handled using suitable lifting equipment (due to
weight, considering the type of batteries chosen, and coupling system).
The batteries must be in accordance with CEI 21-5 Norms.
The machine and its battery check card foresee the use of traditional
lead batteries.
CHECK THE SETTING OF THE CHECK CARD (see under paragraph
"BATTERIES CHARGE LEVEL INDICATOR").
In case of GEL batteries installation, it is necessary to set the check card.
Please contact the authorized technical assistance.
Strictly follow manufacturer/distributor indications for the
maintenance and recharge of the batteries. All installation and
maintenance operations must be executed by specialized staff, using
suitable protection accessories.
For batteries installation it is necessary to reach the battery
compartment as indicated under paragraph “ACCESS TO THE BATTERY
COMPARTMENT”.
1.
Place the batteries in its compartment.
2.
Connect the terminals, respecting the polarities, avoiding
contact with other parts that could create short circuit.
ASSEMBLING OF THE ROLLBAR
For packing reasons, the support of the blinking light is supplied
disassembled.
Proceed as follows:
Take off the four fixing screws (1) from the rollbar.
Place the rollbar into their seats (2) on the tank.
Fasten the screws passing them in the same order in their holes
foreseen on the support.
Complete the assembly connecting the connectors (3) to supply the
blinking light.
BATTERY CHARGER
Make sure that the battery recharger is suitable for the installed
batteries both for their capacities and type (lead/acid or GEL and
equivalent).
In the plastic bag containing the use and maintenance you will find the
coupling connector for the recharger. It must be assembled onto the
cables of your recharger, following the instructions given by the
manufacturer.
CHARGING THE BATTERIES
1.
Plug the connector (3) of the battery recharger into the battery
connector.
2.
Proceed for the recharging.
