extended storage (greater than 2 months) will not bring the
battery pack to its normal operating capacity. After repeating the
charge/discharge cycle two or three times, the operating capacity
will increase to normal.
Please charge the battery pack as follows:
1.Make sure the battery pack contacts are in contact with the
charging terminals.
2.Slide the battery pack or transceiver with a battery pack into the
desktop charger.
3.The charging LED lights red and charging begins.
4.After charging about 4 hours, when the light turns to green, it
means the battery pack is fully charged.
5.Then you can take off the battery pack or transceiver with the
battery pack and use it.
Installing/Removing the Battery Pack
To install the battery pack, Fit the extensions at the bottom of the
battery into the slots at the bottom of the transceiver’s body. Press
the top part of the battery towards the transceiver until a “click” sound
is heard.
To remove the battery pack, Slide the battery latches, on both sides
of the battery, downwards. Pull the top part of the battery away from
the transceiver’s body, and lift the battery from the transceiver’s body.
