DTU2xx Data Logger Series
User Guide. r. 2.1 | 2021-11-10
Tel.: +420 538 890 720
22
e-mail: [email protected]
7.
After power supply is switched on, the data logger will automatically configure the device inputs
in accordance with the settings of the internal software, after which it will initiate network
registration and connection with the
the
ST2, ST3
indicators should light up
)
,
synchronize the time and start transmitting the data.
After all data is transmitted, device will reboot and reconnect to the server.
8.
After about 1 minute after connecting the
power (this time is required to configure
the inputs and establish a connection),
press the
SB
button to transmit the
readings to
server.
Remember or write down the meter
readings at the time of pressing the
button. You will need this data for the
subsequent entry of initial readings.
9.
After 20-120 seconds, the indicators will go off, while the device's microprocessor will continue
working, and the power of the module will be turned off - the device will go into a sleep mode.
10.
After pressing the button and recording data, you can leave the object on which the data logger
is installed. You can make further configuration of the device remotely, via the server web interface
Fig. 20. SB button.
