Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
Modbus TCP Slave / KNX
Document code: MN67815_ENG Revision 1.100 Pagina 15 di 24
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, KNX and Modbus TCP.
By Pressing the “
Set Communication
” button from the main window for SW67815 (Fig. 2) the
window “Set Communication” appears (Fig. 3).
The window is divided in two sections, one for the KNX and one for the Modbus TCP.
The means of the fields for “KNX” are:
In the field “
Type
” the type of KNX is defined (fixd to ‘KNX TP’);
In the field “
ID Device
” the ID of the KNX side of the converter is defined.
The means of the fields for the “Modbus TCP Slave” section are:
In the fields “
IP ADDRESS
” the IP address that you want to give to the Converter is defined;
In the fields “
SUBNET
Mask
” the SubNet Mask is defined;
In the fields “
GATEWAY
” the default gateway that you want to use is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for going out of
the net;
In the field “
Port
” the TCP port for the Modbus TCP communication is defined.
In the field “
Diagnostic
” insert the starting byte of the memory array where you will save the
diagnostic of KNX. It is possible to enable/disable this function using the checkbox.
For more informations about the diagnostic, see “Diagnostic” section on page 20.
Figure 3: “Set Communication” window