high-grade, the beeper will beep once, P3 indicator appears on the screen, and the
indicator flashes three times, indicating that the appliance is in high-grade mode. Press
the function button again, you can choose low, medium and high gear, P0 indicator
appears on the screen, and the indicator flashes three times, indicating that the appliance
is in stand by mode. Continuously press the function button, “P0 - P1 - P2 - P3 - P0”
appears on the digital tube as a circulation , corresponding to the appliance mode is
“Stand-by ---Low-grade---Mid-grade---High-grade---Stand-by”.
3. In stand by mode, press the timer button, the appliance can set time from 1 to 24 hours.
After set the time, the indicator next to the digital tube will light up, it means that the
appliance has been selected timer function. "0" indicates time not set.
4. When the appliance is on working, the digital screen always shows the power state
(P1-P2-P3). The timer setting, when the indicator lights up, it means that the machine has
been set a timer function from 1 to 24 hours. To view the regular time, press the timer
button, the appearing time is the present setting time, at this time the indicator also flashes
three times continuously, indicating that the appliance enters into the timer setting state.
7.3 Manual Operation
Control through the main module on the heater:
P0 indicator appears on the screen when the heater is switched on and it is in stand by
mode.
The 1
st
digit on the screen illustrates P symbol while 2
nd
digit illustrates power level mode
from 1 to 3.
The button number 1 on the heater functions as ON / OFF. The heater starts operating at
the power level mode at which it has been switched off.
Press the button number Temi on the heater to adjust power mode.
P0 appears on the screen when pressed ON / OFF button and the power level mode (P1
，
P2
，
P3) can be adjusted through the buttons on the remote control.
Press ON / OFF button on the remote control or the heater itself to switch off the heater.
The heater starts functioning in stand by mode after electricity cut.
LED keeps flashing in case of a program set by remote control.
Buzzer signal is given following each command.
LED
Power level indicator
