Transportation and Handing
When transportation, hold the base and lift the freezer carefully with the tilted
angle more than 45 degree. Never hold the door handle as support. Never
place it upside down nor horizontal wise nor get it extruded. Push freezer
about by making its two hind roller feet as axis and then tilting it slightly
during moving indoors.
Installation
1. Install the freezer at a place with a flat, firm ground directly. In order to
prevent vibration and noise.
2. Choose a well-ventilated place. A space of no less than 10cm must be left
around the refrigerator.
3. Choose a location where there is no heat source. Keep the freezer away
from direct sunlight and oven etc..
4. Choose a dry and well-ventilated place where there is no corrosive air.
Testing
1. Clean the freezer with lukewarm water and detergent, and wipe dry.
Notes: Electrical components should be cleaned with a dry cloth.
2. Turn the thermostat knob to the "MED" position, and plug the freezer into
the wall outlet. The compressor will begin to run.
3. Check, after 30 minutes of operation, to ensure that the freezer is cold.
Temperature Control Panel
Setting the temperature using the knob located inside the fridge compartment:
MIN for less cold to MAX for colder
Press super freezer knob, begin to super freezing ; and press again, stop super
freezing.
NOTE:
1. Turning the temperature control to "OFF" position stops the cooling cycle
but does not shut off the power to the freezer.
2. If the unit is unplugged, power lost, or turned off; you must wait 3 to 5