Page 10
Manual SVA alarm dialler | Back to
Adesys B.V. | Wateringen
•
The notification appears on the mobile phone to which the SMS message has been sent; this message
can be structured as follows:
LOCATION powerfailure Active
;
•
The red LED (error) continues to show the status of the mains power failure until this has been
recovered.
A mains power failure message always takes priority over an ongoing notification of a status change. After
notification of the mains power failure, any interrupted notification can be restarted. Notification of status
changes that have not yet been notified then continues. This priority arrangement applies for both
Active
and
Idle
.
5. Output switching by SMS
With the SVA, the output channel can be switched by means of an SMS message. The SMS message should
be structured as follows:
#<Command><parameter1><parameter2>#
• Command
= O (Output).
• Parameter1
= A (Active) or I (Idle) or P (switch Pulse, default: 2 seconds active).
• Parameter2
= I/O number.
The output number is not the same as the relay number. Relay number 1 is output 5.
Figure 3 Connectsticker
Example SMS message to relay 1:
•
Output 5 active: #OA5#
•
Output 5 Idle: #OI5#
•
Output 5 with default Pulse: #OP5#
•
Output 5 with 8s Pulse: #OP58#
•
Output 5 with 20s Pulse: #OP520#
6.
Import and export of settings
It is possible to export via SV-prog settings:
• for importing to the same type of detector;
• as a backup when settings are changed.
When importing to another detector it is important that it meets the following criteria:
•
the detector is of the same type: SVA2000I to SVA2000I
•
the settings are of the same version:
• 1.3.7 and lower contains version 2
• 1.4.1 and higher contains version 3
• 1.5.0 and higher contains version 4
• 1.6.0 and higher contains version 5
