8-1
1
7
B=04
B
B
B
TOP
B
4 x 30
mm
Screw
ATTACH THE TOP
A
A
A
A
•
Attach the top of the unit (part 01) by first aligning the
4
dowels
(part A) that you installed in the side panels (parts 02 & 03) in
step 1 with the pre-drilled dowel holes in the top (part 01).
•
Once aligned, push the the top (part 01) to the partially
assembled unit until flush.
•
Secure the top (part 01) to the unit using 4 part B screws on
each corner as shown.
•
Part B screws should just be tight. Do not try to force or over-
tighten screws as this could cause damage to parts.
NOTE: It is easier to secure the top (part 01)
with the screws (part B) with the the unit
turned over (upside down) and on a hard,
clean surface.
K
K
K
K
K
K
K
K
K
K
K
27
mm
27
mm
90
°
°06
90
°
8
K=11
Back Panel
Nail
ATTACH
THE
BACK PANEL
Before attaching the back
panel, make sure the unit is
assembled squarely. Use an
"L" Square tool, if necessary,
as shown.
•
First make sure the unit is assembled squarely. Use an "L" Square tool, if necessary.
•
Once the unit is square, you must determine the square installation of the back
panel. Use an "L" Square tool, if necessary.
•
Once you have positioned the back panel (part 08) squarely, secure it to the unit
using 11 of part K nails evenly spaced, as shown.
•
It is very important that you utilize all 11 nails. It strengthens the unit.
!
Use all back panel
nails (part K)
evenly spaced.
They
make the
unit strong.
03
0
1
0
2
08
NOTICE:
7+(:5,77(1
,16758&7,216
CONTAINED
+(5(,1$5(
&23<5,*+7('
