adept technology IO Blox, User Manual

Page: 14 / 52

Chapter 2 - Installation
14 Adept IO Blox User’s Guide, Rev B
Figure 2-5. IO Blox Mounted on Inner Link
Cable Installation
1. Locate the IO Blox-to-Robot cable supplied with the system.
2. Connect the end of the cable with the matching D-sub connector to the IO Blox
connector on the robot. See Figure 2-5 .
3. Connect the other end of the cable to the JCBL1 connector on the IO Blox. See
Figure 3-1 on page 27 for the location of the JCBL1 connector.
NOTE:
To install multiple IO Blox devices, see “Installing Multiple IO
Blox Devices” on page 10 .