ADE GW400 Series, Operating Manual

Page: 10 / 16

10 GW400-210408-Rev004-UM-en
Replacing/inserting the battery
If the usage time is drastically reduced when the battery is fully charged, it must be replaced.
In this case, please contact your local dealer or service partner.
Make sure you remove the battery when the scale is permanently operated
from the mains supply.
If the scale will not be used for a long time, unplug the charger from the
mains supply to protect the battery.
To change or remove the battery, switch off the scale and disconnect it from the power supply.
After about a minute, open the battery compartment on the underside of the scale.
Remove the battery from the battery compartment, disconnect the connectors from the cable
lugs and replace the battery.
Installation proceeds in the reverse order.
Faults and error messages
Below you will find a list of possible errors and faults. If necessary, these can be eliminated
with simple means. If the fault or error cannot be eliminated or other error messages occur,
please contact your service partner.
Faults
Fault Cause Measure
The display
shows nothing.
The scale has switched off
automatically.
Switch on the scale.
The scale is not connected to the
mains. Use the optional mains adapter to
connect the scale to the mains.
Weight display is
unstable.
Draughts or air movements
Close the window.
Choose a different location.
Vibrations
Avoid vibrations.
Choose a different location.
Electromagnetic fields / static
charging
Choose a different location. If
possible, switch off the interfering
device.
The weighing
result is
obviously wrong.
The scale is not levelled
properly.
Adjust the support feet. Use the
spirit level to check the horizontal
position.
The scale is not operating in the
specified temperature range. Operate the scale only in the
permissible temperature ranges.
Electromagnetic fields / static
charging
Choose a different location. If
possible, switch off the interfering
device.
Zeroing is not
possible.
Zeroing is not possible if the
displayed weight e/- 2%
of the capacity of the scale.
In this case, switch the scale off and
on again.