SmartView
Installation and Use
Page 11
In configure mode, options are entered by typing a letter followed by a number
followed by (enter). Use ESC to abort the entry of an option. The SmartView will
remain in configure mode until you type 'E' (enter).
For example: to set hotkey option 2 type the following at the 'C' prompt
(at SmartView 'C' prompt)
H
H 2
2 e
e
To exit configure mode type:
E
E e
e
2.6 Summary of SmartView configuration options
Full details of each of the configuration options and their uses are given in section 4.
B1
- screen saver disabled (default)
B2
- Blank screen after 1 minute of inactivity
B3
- Blank screen after 2 minutes of inactivity
B4
- Blank screen after 4 minutes of inactivity
B5
- Blank screen after 8 minutes of inactivity
B6
- Blank screen after 12 minutes of inactivity
B7
- Blank screen after 16 minutes of inactivity
B7
- Blank screen after 20 minutes of inactivity
D1
- Display dot flashes to indicate activity, right handed auxiliary display (default)
D2
- Display dot does not flash, right handed auxiliary display
D3
- Display dot flashes to indicate activity, left handed auxiliary display
D4
- Display dot does not flash, left handed auxiliary display
D5
- Display dot flashes, auxiliary display port configured for monitor light module
D6
- Display dot does not flash, auxiliary port configured for monitor light module
L1
- SmartView locks on to active ports only during autoscanning (default)
L2
- SmartView locks on to every port during autoscanning
L3
- SmartView powers on in autoscan mode and locks on to active ports only
L4
- SmartView powers on in autoscan mode and locks on to all ports
L7
- SmartView cascade query code = AD (default)
L8
– SmartView cascade query code = EF
