g
Set the OPTIONS port baud rate
1200
2400
9600
19200
38400
57600
115200
Enter the
Functions
menu
Show current firmware version
Reset configuration to factory defaults ( is displayed momentarily)
Enter the
Hotkey
menu
Ctrl + Alt
Ctrl + Shift
Alt + Shift
Right Alt
Alt
Left Ctrl + Alt
Right Ctrl + Alt
Hotkeys disabled
Set a new password for use with the lock mode
Enter the
Switch Mode
menu
All
KVM + Speaker
KVM only
Speaker only
USB1 only
USB2 only
Enter the
User Preferences
menu
Enable mouse switching
Disable mouse switching
Cycle all ports (when using ‘ Tab’ or ‘Autoscan’)
Cycle only active ports (when using ‘ Tab’ or ‘Autoscan’)
You can press
at any point to exit
from an option and
return to the main
menu ( ) section.
Configuration
Using the configuration menu
configuration menu
The configuration mode allows you to determine numerous aspects of the
CCS4-USB unit capabilities.
To use the configuration menu
During normal use, the seven segment display on the control panel shows the
number of the currently selected computer channel. From this condition, enter
configuration mode as follows:
1 Press and hold the control panel
COMPUTER
button for roughly five seconds.
The display will show:
2 On the keyboard, press the letter key for the required menu section, e.g.
The display will show the pressed letter, e.g.
3 Press the number of the required setting, e.g.
The display will show the pressed number, e.g.
4 Press
to accept the setting and return to the main menu section.
The display will show:
5 You can now continue with your next configuration change (go to step 2),
or exit from the configuration menu (see below).
To exit the configuration menu and save changes
• Press and then press
to exit and save changes.
To exit the configuration menu without saving
• Press either of the front panel buttons.
SECT 3
