AdderView MP
Installation and Use
Page 17
To enter configure mode at power on:
Switch off all the attached computers and the AdderView MP. Hold down the front
panel key whilst powering on the AdderView MP. Remember that the AdderView MP
draws its power from any attached PC via the keyboard cable and so will power itself
on when the attached PC is switched on or when the optional power adapter is
connected. Do not release the key until the AdderView MP displays 'u'. Whilst the
AdderView is displaying 'u', press and hold down the front panel key for 5 seconds
until the AdderView MP displays 'C' to show that it has entered configure mode.
If you wish you may use the reset switch that is situated on the underside of the
AdderView MP (see figure 4) to perform a power-on reset without powering down
the connected computers.
To enter configure mode whilst the AdderView MP is running:
Hold down the front panel key for 5 seconds until the front panel display shows ‘C’.
In configure mode, options are entered by typing a letter followed by a number
followed by (return). Use ESC to abort the entry of an option. The AdderView MP will
remain in configure mode until you type 'E' (return).
For example: to set hotkey option 2 type the following at the 'C' prompt
(at AdderView MP 'C' prompt)
H
H 2
2 f
f
To exit configure mode type:
E
E f
f
