10
WWW.ADDC.NET | 516.673.4444 | [email protected] | ALL PRODUCTS ARE PROUDLY MADE IN THE USA
Section 2.4 - Installing Your SR-20RM Power Supplies
Section 2.4.1 - Remove an SR-20RM Power
Supply
1. Push SR-20RM Power Supply locking tab to the left.
2. While holding the locking tab, pull the SR-20RM Power
Supply handle and remove.
Section 2.4.2 - Install an SR-20RM Power
Supply
1. Locate an empty SR-20RM Power Supply bay
2. Push the SR-20RM Power Supply straight into the
SR-20RM Chassis
3. Connect your AC Power Cord into the replacement
SR-20RM Power Supply
4. You should see the "OK" LED illuminated green.
Handle
Tab
Correct orientation pictured, inserting power supplies upside down may damage the system.
The SR-20RM requires one power
supply for the system to operate
optimally. Each power supply powers 10
PC cards.
To ensure redundancy see the power
supply schemas in
Section 2.6
.
Remove and replace only one power
supply at a time in a system that is to
always remain powered on.
A
fter installing a new power supply
allow several seconds for the system
to recognize the new component. The
power supply OK status indicator will
turn green to signify that the power
supply is functioning properly.
