ADD-A-BATHROOM Pty Ltd. Specifications and details subject to alteration without notice. (c) 2019
No warranty is expressed or implied by the publication or use of this guide. Page 3 of 8
TYPICAL ASSEMBLY AND INSTALLATION DRAWINGS
Panels, sizes and waste locations vary between units.
Note: Poor or inadequate installation of sealant may be the cause of leakage. Do it right the first time.
Please read the sealant use guide provided.
Sequence of panel assembly for all standard 8 panel, tile look flat pack bathrooms.
The initial beads of sealant to be applied in the shower areas are indicated by the coloured lines and the letters
C,E,H,K; referencing the relevant section of the assembly guide instructions. Normally it is not necessary to apply
any initial beads outside of the shower area (as indicated by H in pink). However, should local requirements
dictate a fully sealed room (which would be unusual) all joins (other than the ceiling) should be so sealed.
LEFT HAND SHOWER SHOWN