ADCA
VAL
S
TEAM
ADCA
We reserve the right to change the design and material of this product without notice.
IMI PV25G.20 E 04.16
-
Do not remove the nameplate attached to the equipment. Serial number and other useful information is
stamped on it.
-
Do not apply the v
alve for oxygen service, if it hasn’t been specifically manufacture for that purpose.
-
During the assembly work, apply protective measures against dirt.
-
When connecting flanges, the bolts should be mounted from the counter flange side with the hexagon nuts from
the valve side and it must exist a perfect match between the connection flanges.
-
Tighten flange connection bolts uniformly in a diagonal sequence.
-
Damaged diaphragms can result in a dangerous media leak through the vent hole. To avoid this, valves should
be requested with appropriate connection in order to allow the connection of a pipe to a safe place.
-
Correct installation of the equipment is full responsibility of the contractor
-
Valves are designed to be applied in places protected from exposure to weather.
-
We recommend special constructions or protective measures for applications on the outside or in adverse
environments like corrosion-promoting conditions (sea water, chemical vapors, etc).
-
Avoid painting the bonnet thread (if applicable).
TRANSPORT AND STORAGE
-
Handling and lifting of materials should be made with adequate equipments.
-
Do not damage the paint job. It protects against corrosion during transportation and storage.
-
The valves and equipments should be protected from impacts and forces during transportation and storage.
-
The manufacturer doesn’t assume the responsibility of damaged equipments due to inappropriate handling
during the transportation and storage.
-
When applicable, the valve should be handled with lifting eyes.
INSTALLATION
-
Account for over pressure conditions, according with the local laws or standards.
-
Valve mountings such as actuators, handwheels, hoods must not be used with other purpose than the one they
were built for (e.g. climbing aids or as connecting points for lifting gear)
