ADC Ultra-8, Operator'S Manual

Page: 8 / 15

Page 7
Advanced Digital Controls Advanced Digital Controls
AS208-OM-V1.1
Menu
ê ê
- Keypad Lock Mode
This command will lock the keypad from any wandering hands. The MENU Button will
flash to indicate that the keypad is locked. To unlock the keypad press Menu
ê
ARMING THE PANEL IN AWAY MODE ARMING THE PANEL IN AWAY MODE
+ +
OR
3-6 Digit
Co d e
Press the
AWAY
key. The AWAY indicator will come on. Your panel will begin beeping
its exit delay. During this time it is optional to press the
AWAY
key again to disarm. (to
prevent accidental arming, the panel can be programmed to require a code to arm the
panel. To do so press AWAY and enter your code followed by the
ENTER
key.
ARMING THE PANEL IN STAY MODE ARMING THE PANEL IN STAY MODE
+ +
OR
3-6 Digit
Code
Press the
STAY
key. The STAY indicator will come on. Your panel will begin beeping its
exit delay. During this time it is optional to press the
STAY
key again to disarm. (to
prevent accidental arming, the panel can be programmed to require a code to STAY arm
the panel. To do so press STAY and enter your code followed by the
ENTER
key.
When arming STAY mode all exit and entry delays will apply as programmed, however if
the
ENTER
button is pressed after arming STAY mode, then all exit and entry delays will
be cancelled for that armed cycle making everything instant.
DISARMING THE PANEL DISARMING THE PANEL
+
3-6 Digit
Code
To disarm the panel, enter your 1 to 6 digit code then press the
ENTER
key.
If your system has an optional radio card installed your system can also be armed or
disarmed with your remote key fob pendant.
ADDING OR DELETING CODES ADDING OR DELETING CODES
The
Ultra-8
can accept as many as 10 different user codes of 1 up to 6 digits in length.
Your installer can set you up to enter your code at user code 1 (Master code, Default to
2580) You will now be able to add, delete or change codes for other users.
By default only the master code has permission to change add or remove codes. Any new
codes added will be able to arm, disarm and put either area of the panel into monitor
mode. User codes can be limited in their levels of permission if required. Please ask your
installer.
www.msealarms.com.au