ADC HiGain Wideband 3190, Installation And Verification Manual

Page: 70 / 108

Installing Multiplexers LTPH-SM-1052-04
58 July 14, 2002 HMS-358 List 5 and List 6
HXU-3
5
8
/HXU-3
6
0
Placing the Line Unit in Service at the HXU
The Wideband 3190 interfaces internally to the 28 lines at the common DSX-1 point. Once a line has been configured
on the HLU, the DS1 interface at the HXU should be placed In-Service. Some alarm reporting will be lost if the
line is not placed In-Service.
The procedure to place a line unit in service varies by the type of multiplexer installed:
•
If you have an HXU-358 or HXU-360—DS3 (T1/E1), see “Placing the Line Unit in Service Using an
HXU-358 or HXU-360 Multiplexer” on page 58 .
•
If you have an HXU-359—STS-1, see “Placing the Line Unit in Service Using an HXU-359 Multiplexer” on
page 60 .
Placing the Line Unit in Service Using an HXU-358 or HXU-360 Multiplexer
Step Procedure Installer Check
ü
The following procedure assumes proper TAO login.
For proper login procedure, please refer to
“Using the Terminal Access Option” on
page 27 .
1 From the Shelf Options screen, select .
H
2 Select the Config menu and then press .
H
3 Select the T1/E1 Ports menu and then press .
H
4 Select the Port #, use the to select IN-SRVC, and then press .
H
5 Press to return the Shelf Status menu.
H
6 Proceed to “Enabling Alarms for Systems Using an HXU-358 or HXU-360 Multiplexer” on page 59 .
H
Installer Signature
?
Date
Once a line is placed In Service under the HXU Configuration Management menu, its
provisioning cannot be changed. To reprovision a line, place it in maintenance mode
(Unequipped and Out-of-Service). This does not affect changing DS1 parameters under the
HLU Maintenance Terminal menu.
M
ENTER
ENTER
SPACEBAR ENTER
ESC