ADC HiGain Wideband 3190, Installation And Verification Manual

Page: 39 / 108

LTPH-SM-1052-04 Installing a Management Unit (HMU)
HMS-358 List 5 and List 6 July 14, 2002 27
U
SING THE
T
ERMINAL
A
CCESS
O
PTION
You can use the Terminal Access Option (TAO) interface to access and manage all the components of the
HMS-358, including the line units, multiplexers, shelf, and the associated doublers and remote units.
Depending on the version of HMU software you are using, the logon procedure varies. At the time of this writing,
all versions of software respond to at least one of the logon procedures described below. Select the logon
procedure that applies and follow the instructions.
•
Upon successful logon to a single-shelf system, the Shelf Status screen appears ( Figure 19 on page 28 ).
•
Upon successful logon to a multishelf system, the Network Status Screen appears ( Figure 18 on page 28 ).
Select the shelf you wish to view. The Shelf Status screen appears.
Proceed to “Configuring the Management Unit” on page 29 .
Procedure 1 1 At the prompt, type tao , then press
.
2 At the “enter password” prompt, type
public
(default password) and press .
Procedure 2
1 At the prompt, type
tao
, then press .
2 After the message, “Please Log off TL1 session and retype TAO,” type
logoff
, and then type a
semicolon (;).
3 After the “Logged out OK” message, type
tao
, then press .
4 At the password prompt, type public (default password) and press
.
Procedure 3
1 At the prompt, type
tao
, then press .
2 After the message, “Please log on to local TL1 with proper privilege and re-type TAO,” press .
3 At the “Enter TID [local]” prompt, enter the ID (if necessary) or press
.
4 At the “Enter username” prompt, type
superuser
(default username), then press .
5 At the “Enter password” prompt, type
public#1
(default password) and press .
6 At the TL1 prompt (<), type
tao
and press .
If you forget your password, contact ADC Technical Assistance Center (see “Appendix E -
Product Support” on page 84 ). For more information about passwords, refer to the HMU user
manual.
Installer Signature
?
Date
Contact the Technical Assistance Center (TAC) for information on using the Transaction
Language 1 (TL1) command line interface for the following command sets:
• HXU-358 List 1 (M13) TL1 Command Set
• HXU-359 List 1 (STS-1) TL1 Command Set
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER