ADC Campus-REX2 RS, User Manual

Page: 109 / 166

Campus-REX2 RS Interface Card User Manual 97
7
U
SING THE
LCD
FOR
C
ONFIGURATION
AND
M
ANAGEMENT
This chapter describes how to use the LCD to set the Campus-REX2
configuration options.
The steps in this section use the menu buttons and LCD on the front of the
desktop unit or the Campus-Star Campus Management Unit (CMU) to
configure the Campus-REX2. With the default settings, the Campus-REX2 is
set to operate:
•
with the HDSL Operating Mode set to Standard Mode
•
with the Standard Mode HDSL Rate set to T1
•
as a bridge, with the encapsulation format set to cHDLC and
Spanning Tree protocol disabled
•
with the Timing Source set to Internal
Depending on the requirements of your network, you may be able to use the
default settings for one or more of these options.
For: See Page:
Navigating the LCD Menus 98
Setting the HDSL Parameters 99
Configuring the Campus-REX2 103
Restoring the System to Default Values 108
Viewing and Configuring Alarms 109
Configuring Loopbacks 113
Viewing System Information 115
Viewing Status Information 115