35
10) Insert bolts into the holes of the taper lock bushing and thread into the motor pulley, then tighten
evenly
.
11) Check that the motor pulley is properly aligned.
16) Reinstall the V-belts removed in
Step #2
.
17) Tighten the turnbuckle.
IMPORTANT:
DO NOT
OVERTIGHTEN TURNBUCKLE.
18) Reestablish electrical service to the dryer.
e. Pillow Block Bearing Removal
1) Discontinue electrical service to the dryer.
2) Follow
Step #2 thru Step #17
of the
Tumbler (Basket) Drive Wheel Replacement
instructions
on
page 32 and page 33
.
3)
Carefully
file the score marks on the drive shaft from the set screws and lightly sand the shaft with
a light grit sand paper before removing the pillow block bearings.
4) Loosen the set screws and remove the pillow block bearing.
5) For replacement of the pillow block bearings reverse the above procedure,
Step #4 thru Step #2
.
IMPORTANT
: Remove the wooden blocks that were inserted under the tumbler (basket).
6) Reestablish electrical service to the dryer.
f. Gear (Speed) Reducer Replacement