The D-SERV menu is divided into an upper section and a lower
section. The lower section can be viewed by typing
LM
.
The function of the commands listed in the D-SERV menu are the
same as the DataSMART DSU command functions. The response from
the D-SERV DSU/CSU will be different from the response from a
DataSMART DSU since the D-SERV DSU/CSU is not as feature rich.
The D-SERV DSU/CSU will respond to report requests from
DataSMART DSU for
RUNLR
,
RUNSR
,
RCNLR
, and RCNSR over
the Facility Data Link.
Refer to the DataSMART DSU Operator Manual for information on
the commands in the D-SERV menu, alarm parameters and reports.
Remote Loop Backs
A far end DataSMART or a test set can set a Line Loop Back (LLB), a
Data Port Loop Back (DPLB) or a Payload Loop Back (PLB) on the
D-SERV DSU/CSU (see codes on
page 3
). These loop backs can be reset
or overridden by the Loop Back Switch on the D-SERV DSU/CSU.
Refer to the DataSMART DSU Operator Manual for detailed
information on these loop backs.
D-SERV
T1
DSU/CSU
V1.01
Copyright
(c)
1992
Kentrox
, LLC
NAME:
PORTLAND, OR
S
- System Status Screen
NSR / AHR
- Network Statistical and Alarm History Report
NCV
- View Network Configuration
RLB
- Reset Loop backs
DRC
- Disconnect from Remote Unit Control
MM
- Main Menu
LM>
Figure 28. D-SERV Lower Menu (LM)
Operator's Manual
41