DB 6520
© (2014) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Router Installation
13
To connect the Ethernet cable:
1.
Connect one end of the Ethernet cable into one of the four Ethernet ports on
the rear of the Router
2.
Connect the other end of the Ethernet cable into the Ethernet Network card
of your computer
3.
Verify if the Ethernet Network card is configured as DHCP client, otherwise
configure it to remain in the same local network of the router interface (see
chapter “Setting Up Your Computer”)
FIGURE 3.
Ethernet Cable Connection
ETHERNET CONNECTION
You have to verify the existence of a TCP/IP protocol stack and, then, according
to your Operating System, to establish an Ethernet connection to the Data
Gateway. This connection will require you to enable your computer to receive