3
GETTING STARTED
UNPACKING YOUR DIGITAL RECEIVER
FRONT PANEL
Receiver
Power Supply
Installation
Guide
Quick Installation
Guide
HD TV
Power supply
Home Cinema
Ethernet
router
SD TV
SD card slot
Led indicator in the power on/off button:
Blue
- operating mode. Blinks while receiving signals from the RCU
Red
- deep standby mode
Purple
- normal standby mode. Blinks during software update.
Rec LED
- Red when recording is in progress (only when the ADB HDD
module is connected).
WiFi NETWORK CONFIGURATION
If you decide to use wireless network please perform the steps listed in the
“Connections” section. Make sure the ethernet cable is disconnected. On
your TV the “Application Screen” shall appear:
1. select the WiFi network from the list,
2. enter the password if applicable.
The front panel LED indicator shall display the following information:
CONNECTIONS
Installation Notice
: Connecting your TV directly to the Audio/Video
output of your Set-Top Box will assure a more vivid picture and enhance
your viewing enjoyment.
Plug in all cables before connecting the decoder to the power supply.
Similarly always unplug the decoder from the power supply first, before
disconnecting cables from the decoder or reconnecting them.
1. Connect the Ethernet cable
or
configure WiFi network.
2. Depending on the type of your TV set, connect your receiver either
with the HDMI cable (for an HD TV set), jack connector (for an SD
TV) or RF cable.
3. You can also connect audio devices such as home cinema.
4. The last step is connecting the decoder to the power supply socket.
Now you can switch on your TV set. Make sure that you have selected
the appropriate source of signal in the TV. If you are unsure how to do it,
please consult your TV user manual.
Red bar - no network connection.
Blinking red bar - connecting in progress.
Two yellow bars - poor signal.
Three blue bars - medium strength.
Four blue bars - strong signal.
RF RCU CONFIGURATION
Important
: Remote Control Unit is packed separetly.
In case when you are provided with an RF RCU please perform
simultaneously the following steps in order to pair it with your STB:
1. RF RCU - enter the pairing mode according to the instructions
attached to the device.
2. STB - please keep the On/Off button pressed for 5 seconds.
