Adaptec USBConnect2000, User Manual, Page: 9 / 26

3
Installing the USBConnect 2000 adapter
Installing the USBConnect
2000 adapter
The following information describes the hardware and software
installation for the USBConnect 2000 adapter.
Hardware Installation
Follow these steps to install the USBConnect 2000 adapter:
1
Remove the USBConnect 2000 adapter from its packaging.
2
Connect the USBConnect 2000 adapter into the SCSI device
you want to connect.
3
Connect the USB connector (small end) into your systems USB
port. (See diagram below.)
4
If attaching the USBConnect 2000 adapter through a USB hub,
we recommend using A/C powered hubs.
Note:
The USBConnect 2000 adapter receives its +5V
power from the terminator power line of the attached SCSI
device. See
Terminating the SCSI Bus , on page 8.
USB Port
USB Connect