A-6
Adaptec RAID Configuration Utility
■
Adaptec does not recommend that you migrate or build an
array on Windows dynamic disks (volumes), as it will result
in data loss.
Caution:
Do not interrupt the creation of a RAID 0 using the
Migrate option. If you do, there is no way to restart, and
no way to recover the data that was on the source drive.
5
When you are finished, press Done.
Initializing Disk Drives
If an installed disk does not appear in the disk selection list for
creating a new array or if it appears grayed out, you may have to
initialize it before you can use it as part of an array. Drives attached
to the controller must be initialized before they can be used in an
array.
Caution:
Initializing a disk overwrites the partition table on the
disk and makes any data on the disk inaccessible. If the drive
is used in an array, you may not be able to use the array again.
Do not initialize a disk that is part of a boot array. To
determine which disks are associated with a particular array,
see
Viewing Array Properties on page A-2
.
To initialize drives:
1
Turn on your computer and press Ctrl+A when prompted to
access the ARC utility.
2
From the ARC menu, select Array Configuration Utility
(ACU)
.
3
Select Initialize Drives.
4
Use the up and down arrow keys to highlight the disk you wish
to initialize and press Insert.
5
Repeat
so that both drives to be initialized are selected.
6
Press Enter.
7
Read the warning message and ensure that you have selected
the correct disk drives to initialize. Type
Y
to continue.
!
!
