3-28
Adaptec RAID Installation Guide
4
To run the
installpkg
utility, type
installpkg -d disk/
.
SCO UNIX reads the disk and prompts you to enter the
package name to be installed.
5
Type
dpti4
for Open Desktop 3.x and
dpti5
for SCO
OpenServer 5.x.
6
After the package is installed, rebuild the kernel.
7
Restart the system.
8
Install the new kernel.
9
Add devices to the controller.
Adding the Controller to an Existing UnixWare 7 System
In this scenario, you are adding an Adaptec RAID controller to an
existing UnixWare 7 system. To install the driver
1
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
Chapter 2
.
2
Download the latest I
2
O supplement for UnixWare 7 from the
SCO Web site—it should be
ptf7066c
or higher.
3
Uncompress the PTF
file
you downloaded in
Step 2
and move
the file to the
/tmp
directory.
4
Use the
pkgadd
utility to install the I
2
O supplement by typing:
pkgadd -d /tmp/ptf7066c
5
Follow the on-screen prompts to install the SCO UnixWare I
2
O
supplement.
6
Shutdown and reboot the system.
Note:
Upon restarting, several warning messages may
appear and scroll off the screen quickly. These will not occur
after
diskadd
is run and can be ignored.
7
Use the
diskadd
utility to add drives or arrays that are attached
to an Adaptec RAID controller.
Combined RAID IG.book Page 28 Thursday, May 3, 2001 11:51 PM
Summary of Contents for ASR-2000S
Page 1: ...R AdaptecRAID Installation Guide ...
Page 35: ......
