© Adam Equipment Company 2021
16
10.0 OPERATIONS
10.1
INITIALISATION
If Operator and Supervisor passcodes have been set, the display will show
“
ΠΑΣΣ ΧΟ∆Ε
”,
shortly followed by
“
0
”.
In this case you must enter the passcode to continue, using the
numeric entry method (see section 10.2). If passcode is incorrectly entered then the
message
“
ΕΡΡΟΡ ΧΟ∆Ε
”
will flash, shortly followed by
“
0
”.
Once a passcode is correctly
entered, or if passcodes have not been set, the balance will continue as below
.
The display will show zero reading along with
the zero symbol “
0
” and the weighing unit
last used. If automatic time calibration is
enabled the balance will calibrate 15 minutes
after power up, or again after the pre-set time
interval.
10.2
PASSCODES
This equipment has passcode security functions which can restrict certain operations to
particular users. Supervisor and Operator modes are available. If no passcode is set then
the default access is Supervisor level. Setting a Supervisor passcode gives the option to
lock down key parameters so that they are not available to be changed by operator-level
staff.
If a passcode has been set to limit access to the weighing functions of the balance then
when reset or turned on, or when the [Setup] key is pressed in Operator mode, the display
will show
“
ΠΑΣΣ Χ∆
”
followed by
“
0
”.
Use the numeric entry method (see section 8.1) to
enter either the operator or supervisor code depending on the access level required. The
display shows the digits entered as they are set. The active digit will have the “-“ symbol
flashing. Make sure to enter the correct passcode to continue. See Section 13.7 for details.
