4
Assembly instructions for fitting an electric or gas fire
Positioning hearth
Diagram A
Carefully unpack the hearth part (d) and position, Ensure hearth is centralised to your fireplace
opening. If installing an electric fire, ensure you have sufficient room for the power cable of your
electric fire to run to a socket
If fitting a gas fire prepare the bedding mixture, which can be sand and cement with an accelerator
added to speed up hardening, or special hearth bedding mixture available ready mixed .Lay the
bedding mixture on the floor, ensuring sufficient depth of mixture to support the surround off the floor
about 12mm .
The hearth must be sealed directly to the bare floor so that no air can enter the flue from
under the hearth. It must not be bedded on to a carpet (applies to gas)
Assemble the chair brick
Diagram B
• Assemble chair brick part (b) to the surround part (C) using the nuts and bolts provided, Assemble
mantle top part (A) using the nuts and bolts supplied.
• Place the nut and bolt on to the screw shaft and align with pre drilled screw holes in the chair brick,
when screw is tight hand tighten nut.
• See Diagram C
Avant Garde
Screw - Hex Set
Nut and Washer
Inser ts through chair
brick into sur round
Diagram C
