ADA INSTRUMENTS ROBOT-60, Operating Manual

Page: 6 / 36

MEASUREMENT FOUNDATION
6
ROBOT 60
Selecting Units
Press and hold the button (3) for sec. until the desired unit is displayed.
Illumination
Press and hold the button (4) for seconds to switch the illumination on or off.
Clear-Key
Cancel the last action. Press button (5).
MEASUREMENTS
Single distance measurement
Press button (1) to activate the laser. When in continuous laser mode, press this button to trigger the distance measurement directly.
Press again to trigger the distance measurement. The result is displayed immediately.
Continuous Measurement
Press and hold the button (1) for about seconds to start continuous measuring.
Minimum/ Maximum measurement
This function allows the user to measure the minimum or maximum distance from a ixed measuring point. It is commonly used to measure room
diagonals (maximum values) or horizontal distances (minimum values).
Press and hold down the button (1). Then slowly sweep the laser back and forth and up and down over the desired target point-(e.g. into the corner of
a room).
Press to stop continuous measurement. The values for maximum and minimum distances are shown on the display as well as the last measured value
in the summary line.