- 4 -
Input Value Limit
Function
Maximum Input and Time
Voltage
AC 500V (within 10 sec) / DC 1000V (within 10 sec)
Current
With an AC/DC 10~15A current (30-sec measurements), there should be at
least 10-minute intervals between the measurements. With a less-than-10A
current, the measurements for a longer period is possible.
Warning
- Extra caution against a high voltage should be taken when using this equipment.
- The inappropriate use of the equipment may cause casualties or electric shock.
- Observe all the safety rules stated in the accompanying manual.
- Ensure the complete use of the provided power connection wire (load wire).
⊙ Safety Instructions
This equipment has been designed in accordance with the CE CAT II & FCC safety standards.
Users, however, must see to it that they have a thorough knowledge of the guidelines for the use of
the equipment, as shown below, and must use it with full attention, to ensure its safe operation.
- Do not load general batteries, only rechargeable batteries, and do not use an AC adaptor while
loading general batteries (the Li-ion batteries are built-in).
- When using the selected function, do not go over the voltage or current limit, which had been set
as the maximum.
Do not attempt to operate the equipment if you cannot close its back cover.
Observe extreme caution when measuring a high voltage.
- Do not attempt to measure the voltage when the input jack is at “COM” and the voltage is 500V
or above at high grounding.
- Do not make a cross-connection between an electric current source and a voltage source.
- When replacing batteries or fuses, make sure to turn the power off before opening the back cover
Warning
If the blinking “
”sign appears on the screen, recharge the batteries immediately or use an adaptor.
For battery recharging, use a 12V 500mA adaptor.
- Recharge the batteries for about five hours, or connect them to an adaptor for five minutes,
before using the measuring device for the first time.
www.biall.com.pl